![background image](http://html.mh-extra.com/html/chief/pt-series/pt-series_installation-instructions-manual_2600938011.webp)
Installation Instructions
TIL1X2PT / TIL1X3PT / TIL1X4PT / TILVABPT
11
Installing Housings and LED Screens
IMPORTANT ! :
Reference the LED screen installation
manual for specific instructions regarding care, handling,
cabling and installation of the LED housings and screens.
NOTE:
Begin the installation of the housings in the lower left
corner of the video wall.
NOTE:
One complete column of housings should be installed
before proceeding to the next column.
Figure 16
1.
Install the first LED housing in the lowest left-hand corner of
the video wall by aligning mounting buttons on the housing
with the mounting holes on the wall mount.
2.
Move LED housing forward until all four mounting buttons are
through mounting holes in wall mount.
3.
Continue with the next housing (directly above installed
housing).
NOTE:
Be sure to check the level and plumb of the housings
often during the housing installation.
4.
AFTER
the
entire
first column of housings are installed, slide
the column to the left side so that the mounting buttons are
against the tapping screws, and to allow clearance for
installation of the second column.
5.
After the second column of housings is installed, push to the
left until the first and second columns of housings are
touching.
6.
Repeat until all housings are installed.
NOTE:
The tapping screws assist in centering the housings on
the mounts.
7.
OPTIONAL:
Remove tapping screws if housings need to be
moved further left or right of center.
8.
OPTIONAL:
Install two 10-24 x 1" Phillips head cap screws
(J)
per housing
on far right and far left column of mounts if
housings need to be moved further left or right of center. (See
Figure 17)
NOTE:
The screws (J) are installed from the right side of the
furthest right wall mount and the left side of the furthest
left wall mount and can be used to push the
housings to
the left or right to slightly level or align the housings by
adjusting the amount of push at the bottom or top of the
housing. The screws (J) can also be used to prevent
removal of the LED screens.
2
LED Housing
[TIL3X3PT wall shown as example]
Begin LED housing install
in the lowest left corner of
the video wall
1
Figure 17
[TIL3X3PT wall shown as example]
[Back view]
8
(J)
8
(J)
Mounting
button