TIL1X2PT / TIL1X3PT / TIL1X4PT / TILVABPT
Installation Instructions
8
12. Drill pilot holes in centerline of lower slots (see Table 1 for
size) and follow fastener information (appropriate for wall
type) located in Table 1. (See Figure 11)
13. Double check the level of the mount along the side of the
mount. (See Figure 11)
14. Fully tighten the 5/16 x 2-1/2" lag screws (C) through the 5/16"
fender washers (D). (See Figure 11)
Figure 11
15. Using a level on the front of the mount in various places, use
a 1" socket and T-handle driver to adjust the leveling feet on
the mount until the mount is plumb. (See Figure 12)
CAUTION:
Over-torquing may cause damage. Do NOT
use a drill to make the depth adjustment.
Figure 12
Adding Additional Mounts
1.
Hold additional wall mount against wall ensuring that
mounting slot is lined up with center line marked on the wall
in
Determining Installation Site
section. Double-check
with a level. (See Figure 6)
2.
Mark mounting holes in two top mounting slots along the
horizontal line. (See Figure 6)
3.
The mounting holes are 17.22" apart on-center. (See
Figure 6)
4.
Drill two pilot holes (same size as those drilled for first
mount) at each marked location and use same fasteners
used on the first mount.
5.
Partially install two fasteners into wall, but do NOT
completely tighten to wall.
6.
Hang wall mount, aligning upper mounting slots over
fasteners, and adjust side-to-side for proper location.
7.
Install two 1/4-20 x 4-1/2" hex head bolts (H) and two 1/4"
steel washers (F) into the right or left side of the second
mount at
both top and bottom
, and through into the left or
right side of the first mount. (See Figure 13)
NOTE:
The second mount may be attached to either the left or
right side of the first already installed mount.
8.
Loosely fasten second mount to first mount using two 1/4"
steel washers (F) and two 1/4-20" flanged hex nuts (E). (See
Figure 13)
9.
Slide adjustment washers (A) behind head of upper fasteners
in mount. (See Figure 13)
10. Tighten both fasteners between mounts (at top and bottom
where the second mount is connected to the first mount).
(See Figure 13)
Figure 13
14
x 2
12
x 2
13
Level
Leveling feet
locations
15
7
Mount already
attached to wall
Additional mount
being added to
first mount
(H) x 2
(F) x 4
(E) x 2
FIRST MOUNT
SECOND MOUNT
8
[TIL1X3PT shown
10
as example]
