Installation Instructions
TIL1X2PT / TIL1X3PT / TIL1X4PT / TILVABPT
9
11. Lay levels across flat of the mounting holes and center-of-
screen indicators, and vertically along side of mount to
ensure wall mount is square and level.
NOTE:
Lift up slightly on the far side of the second mount to help
level the mount.
12. Hold the adjustment washers in place by hand and tighten
the fasteners at the top of the mount.
13. Drill lower pilot holes at attachment locations and use same
fasteners used at top of mount.
14. Install two fasteners through lower part of mount and tighten.
IMPORTANT ! :
For larger LED walls it is helpful to check
placement and alignment of the mounts by putting a few
LED housings in place in the bottom row of the installed
mounts (referencing the LED screen installation manual
for specific instructions) during the mount installation,
checking alignment before removing the housings, and
then continuing the installation.
IMPORTANT ! :
Continually recheck the alignment and
overall flatness of the wall mounts during the installation
process.
15. Continue the installation process until all wall mounts are
attached.
16. Install one #10 x 1/2" Phillips tapping screw (G) into left
upper LED mounting button hole for each LED screen
space. Install the tapping screws ONLY
on the furthest left
column of mounts
. (See Figure 14)
Figure 14
IMPORTANT ! :
The tapping screws keep the LED
screens centered on the mount, and are ONLY installed
on the furthest left column of mounts.
17. Using a drill driver makes installation of the tapping screws
(C) easier.
Model
Fastener
Qty
TIL1X4PT
4
TIL1X3PT
3
TIL1X2PT
2
[TIL1X2PT shown as example]
16
(G)
