Chevrolet 2010 Avalanche, Owner'S Manual, Page: 450 / 582

Brakes
Brake Fluid
The brake master cylinder
reservoir is filled with DOT
3 brake fluid. See
Engine
Compartment Overview
on page 6
‑ 14 for the
location of the reservoir.
There are only two reasons why the brake fluid level in
the reservoir might go down:
. The brake fluid level goes down because of
normal brake lining wear. When new linings are
installed, the fluid level goes back up.
. A fluid leak in the brake hydraulic system can also
cause a low fluid level. Have the brake hydraulic
system fixed, since a leak means that sooner or
later the brakes will not work well.
Do not top off the brake fluid. Adding fluid does not
correct a leak. If fluid is added when the linings are
worn, there will be too much fluid when new brake
linings are installed. Add or remove brake fluid, as
necessary, only when work is done on the brake
hydraulic system.
{
WARNING:
If too much brake fluid is added, it can spill on
the engine and burn, if the engine is hot enough.
You or others could be burned, and the vehicle
could be damaged. Add brake fluid only when
work is done on the brake hydraulic system.
See
“ Checking Brake Fluid ” in this section.
When the brake fluid falls to a low level, the brake
warning light comes on. See
Brake System Warning
Light on page 4 ‑ 31 .
Refer to the Maintenance Schedule to determine when
to check the brake fluid. See
Scheduled Maintenance
on page 7 ‑ 3 .
6-36