Chevrolet 2010 Avalanche, Owner'S Manual, Page: 328 / 582

Using the Dial Command
1. Press and hold
b g
for two seconds. The system
responds with “ Ready ” followed by a tone.
2. Say “ Dial ” . The system responds with “ Dial using
<phone name> ” . “ Number please ” followed by
a tone.
3. Say the entire number without pausing.
. If the system recognizes the number, it
responds with
“ OK, Dialing ” and dials the
number.
. If the system does not recognize the number, it
confirms the numbers followed by a tone. If the
number is correct, say
“ Yes ” . The system
responds with “ OK, Dialing ” and dials the
number. If the number is not correct, say “ No ” .
The system will ask for the number to be
re
‐ entered.
Using the Digit Dial Command
1. Press and hold
b g
for two seconds. The system
responds with “ Ready ” followed by a tone.
2. Say “ Digit Dial ” . The system responds with “ Digit
dial using <phone name>, please say the first digit
to dial
” followed by a tone.
3. Say the digit to be dialed one at a time. Following
each digit, the system will repeat back the digit it
heard followed by a tone.
4. Continue entering digits until the number to be
dialed is complete. After the whole number has
been entered, say
“ Dial ” . The system responds
with “ OK, Dialing ” and dials the number.
. If an unwanted number is recognized by the
system, say
“ Clear ” at any time to clear the last
number.
. To hear all of the numbers recognized by the
system, say
“ Verify ” at any time and the system
will repeat them.
4-120