14
Fitting the Appliance:
Please make reference to the above table and diagrams.
1. Fit the enclosure (1,10,13,14) base in position.
2. Connect the main gas via the flexible gas inlet pipe at the rear of the enclosure
base.
3. Carry out a gas soundness test; if satisfactory then continue with installation.
4. Fit the enclosure cover (2,11) using 2 x fixing screws (7).
5. The URN Bowl casting (4) can be positioned.
6. Fit the bowl location brackets and secure using 4 x fixing screws (8).
7. Fit the burner body assembly (5) over the injector in the enclosure base, ensure the
two location lugs in the burner body assembly line up with the slots in injector plate.
Secure using 1 x screw (9).
8. Fit the top plate (6) over the burner body assembly (5).
When fitting the fire ensure that the unit is fitted under the flue opening so that no part
of the fire bowl protrudes beyond the fireplace opening.
Before connecting the fire unit, purge the pipes from air and debris.
Light the fire on maximum and run for approximately 20 mins and check that the hot
burner pressure is in accordance with the values stated on pages 4 and 5 within the
appliance specifications section.
