32
Thermostatic mode
The handset has within it a thermostat sensor and this can be set so the fire will heat
the room to match he temperature set in the handset.
There are 2 temperature types that can be set:
• Day mode temperature that has a sun symbol on the display
- the default temperature is 24 degrees Celsius.
• Night temperature that has a half moon symbol on the display
- the default temperature setting is 18 degrees Celsius.
Hold handset and press and release the mode button several times as necessary until
the display has a thermometer symbol flashing at the top of the display. Press the set
button to enter this mode.
Press the set button again to see the temperature setting that is set and the mode and
on the left of the display is a sun symbol showing it’s the day temperature.
If a different set temperature is required, while the display is showing this set
temperature press the “+” and “–” buttons to alter the setting. When finished either
press set or leave and after a few seconds the new setting will be accepted and the
display will return to the time of day screen.
The fire will automatically turn to high or low rate depending on the set temperature.
When the set temperature is reached while the fire is in operation, the fire reduces the
burner power level each minute until the burner is off. The pilot will remain on for a
further 30 minutes and if the set temperature is still too high, the pilot will then also
extinguish.
NOTE
: If at any time the power button is operated during Thermostat mode, the
control will cancel any thermostat operation and return the control to manual mode.
Changing the batteries
The batteries should be replaced on an annual basis with quality Alkaline AA batteries.
Handset:
The handset requires 2 x AA batteries, these can be replaced by removing the cover at
the rear of the handset.
Appliance:
IMPORTANT- make sure the fire is turned off and is allowed to cool down before
attempting to handle it, as the appliance will become very hot during operation.
