Page 8 of 28
WELL™ 2.0 User Manual Rev. 01
Master/Slave
Connectivity
The Master/Slave mode allows a WELL™ 2.0 unit to control or more WELL™ 2.0 units
without a DMX controller. See the
Master/Slave
section of the
Operation
chapter for
programming information. The master links to the slave fixtures using the standard DMX
serial connection. If you are not familiar with the Master/Slave connectivity, you may
download the “DMX Primer” document from the CHAUVET® Web site.
Note: This function is not available under wireless operation.
DO NOT connect a DMX controller to the fixtures operating in Master/Slave mode.
Otherwise, the signals from the DMX controller may interfere with the signals from
the master fixture.
The Operation chapter of this manual provides detailed instructions on how to
configure the Master and Slave units.
Mounting
Before mounting this product, read and follow the safety recommendations indicated in the
Safety Notes
section (page 2 of this manual).
Orientation
Always mount this product in any safe position while making sure that there is adequate
room around it for ventilation, configuration, and maintenance.
Rigging
CHAUVET® recommends following the general guidelines below when mounting this
product.
•
When selecting an installation location, consider ease of access to the fixture for
operation, programming adjustments, and routine maintenance.
•
Make sure to place this product away from any flammable material as indicated in the
Safety Notes
section.
•
This unit’s rating is IP 44. Therefore, do not mount the product in places where heavy
rain, water jets, extreme temperature changes, or restricted ventilation may affect it.
•
This is a floor-standing fixture. Do not hang this unit.
Procedure
•
Make sure that you mount this product on a hard, steady surface that can support its
weight.
•
Do not tilt this product further than 10º or mount it on its side.
Mounting Diagram
Retractable
Foot
Correct Floor Mounting
Incorrect Floor Mounting
