WELL™ 2.0 User Manual Rev. 01
Page 11 of 28
Wireless
Operation
The WELL™ 2.0 can operate in W-DMX mode up to 300 m (900 feet) from the W-DMX
transmitter. The W-DMX receiver in the WELL unit must be paired with the W-DMX
transmitter for wireless operation.
Initial Setup
1) Turn the W-DMX transmitter on.
2) Connect the W-DMX transmitter to a DMX controller.
3) Place the WELL™ 2.0 unit within 300 m from the W-DMX transmitter.
4) Disconnect any DMX cable from the WELL™ 2.0 unit.
5) Push the antenna release to allow the W-DMX antenna to extend outside the metal
housing.
6) Set the antenna in the upright position.
7) Turn the WELL™ 2.0 unit on.
Configuration
1) From the WELL’s control panel, go to
RUN > DMX
.
2) Select the start address, as with any other DMX compatible product.
3) Go to
WDMX > ACTI
.
4) Select
ON
.
Fixture Pairing
Fixture Already Paired
1) If the WELL™ 2.0 unit has already been paired with the WDMX transmitter, the red
LED on the On/Off switch will flash slowly.
2) In this case, the WELL™ 2.0 unit is ready to work in wireless mode.
Pairing the WELL™ 2.0 Unit and a new W-DMX Transmitter
1) From the WELL’s control panel, go to
WDMX > REST
.
2) Select
YES
(the red LED on the On/Off switch will illuminate solid).
3) From the W-DMX transmitter, press
<RESET>
(the
SIGNAL
indicator will flash).
4) Once the transmitter has found the WELL fixture, the
SIGNAL
indicator on the W-
DMX transmitter will illuminate solid.
5) The red LED on the On/Off switch will flash slowly indicating the presence of DMX
signal.
WDMX Setup
Control Panel
WDMX Transmitter
