WELL™ 2.0 User Manual Rev. 01
Page 7 of 28
3. Setup
AC Power
The WELL’s battery charger, whether stand-alone or inside the flight case, has an auto-
ranging power supply that can work with an input voltage range of 100~240 VAC,
50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this guide, the product’s user manual, or on the product’s sticker.
Always connect this product’s battery charger to a protected circuit with an
appropriate electrical ground to avoid the risk of electrocution or fire.
Never connect this product’s battery charger to a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer channel serves only as a
0 to 100% switch.
AC Plug
The WELL’s battery charger comes with a power input cord terminated with an Edison plug
(US market). If the power input cord that came with your product has no plug or you need
to change the Edison plug, use the table below to wire the new plug.
Connection
Wire (US)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow/Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
Make sure to disconnect the fixture’s power cord before replacing a blown fuse, and
always replace it with a fuse of the same type and rating.
Fuse
The stand-alone battery charger has no external fuse. However, the
flight case/charger comes with a replaceable fuse (T 6.3 A @ 250 V).
To change the fuse on the flight case/charger, do the following:
1) Disconnect the fixture from the power outlet.
2) With a Phillips #2 head screwdriver, unscrew the fuse holder cap
from its housing.
3) Remove the blown fuse and replace it with a good fuse of the
same type and rating (T 6.3 A @ 250 V).
4) Screw the fuse holder cap back in its place and reconnect power.
DMX Linking
You may link the WELL™ 2.0 to a DMX controller using a standard DMX serial connection.
If using other DMX compatible fixtures with this product, it is possible to control them
individually with a single DMX controller.
If you are not familiar with the DMX standard, or if you need information about the DMX
cables needed to link the WELL™ 2.0 to a DMX controller, you may download the “DMX
Primer” document from the CHAUVET® Web site.
DMX Modes
The WELL™ 2.0 uses the standard DMX data connection for its TOUR, ARC.1, AR1.D,
AR1.S, HSV, and BLOC DMX modes. You will find information about these DMX modes in
the
Introduction
chapter (DMX channel summary), the
Operation
chapter (configuration
details), and the
DMX Values
section (individual channel values).
