28
6 Playback
6.1 Memories
To playback a memory you need to be on the following menu or Run 2 or Run 3 menu screens:
The
Page+
or
Page-
soft-keys will allow you to navigate between the 12 pages of memories.
Each page has nine memories and one sequence stored on it. A lit Yellow LED means that
there is a memory stored on the associated flash button and fader. To replay a memory you can
either raise the fader or press the flash button. You can output more than one memory at a time.
Note that it is possible to set the way the flash buttons work in playback mode. From the main
playback menu select
More..
which will bring up the following menu:
By using the top left soft-key it is possible to set the flash buttons to work in one of three ways:
Flash On
: the memory will trigger when the flash button is pressed.
Flash Solo
: the memory will trigger when the flash button is pressed and all other outputs will
be cut.
Flash Off
: nothing will happen when the flash button is pressed.
6.2 Live!
The
Live!
soft-key allows you to access any fixture or generic channel so that you can alter it. If
you have a memory outputting and select
Live
you can then change outputs as you would in
program mode and save the changes as a new memory or into the currently selected memory.
To do this you would use the
Save As
soft-key.
There is also a
ClearAll
soft-key available as part of the live function. Pressing this key will clear
the HTP outputs. Holding this key down will clear the LTP outputs and home all the fixtures. It is
a useful tool for stopping a show or clearing all outputs to allow you to start programming on a
blank canvas.
Page--
Step---
Run 1
Page Chase
Page+
Live!
Page-
More..
Pg--
Step---
Run 2
Flash On
ProgMem
Sound On
ProgSeq
Dir Fwd
More..
