Chaparral 420 PREMIERE, Owner'S/Operator'S Manual

Page: 146 / 164

9-8
Battery
• Clean battery terminal posts with wire brush or
steel wool before reinstallation and then attach
the cables.
• Check charge on battery. Recharge or replace
if necessary.
• Inspect all battery wiring. Repair or replace
if necessary.
• Attach battery cables, and tighten cable clamps.
• Apply petroleum jelly or marine grade grease on
battery posts and clamps to eliminate air pock-
ets and possible acid buildup.
• Inspect all wiring for fraying, wear, loose con-
nections, or other damage. Repair or replace
if necessary.
Miscellaneous
• Inspect all thru-hull fittings for unobstructed
water passages. Be on the lookout for any dete-
riorated hoses and/or fittings below the water
line that may fail in service and admit water.
• Test the operation of navigation lights and other
onboard lighting. Inspect all switches, controls,
and other related equipment for proper opera-
tion. Repair or replace as necessary.
• Inspect all wiring for fraying, wear, loose con-
nections, or other damage. Repair or replace
if necessary.
• Inspect all life jackets, anchor lines, and other
safety equipment for proper operation and phys-
ical condition. Repair or replace if necessary.
• Check bilge blowers for proper operation. Turn
ON blowers and place hand over hull blower
vent to make sure air is coming from the vent.
• Anchor lines and gear should be inspected and
replaced if necessary.
• Make sure the hull drain plug is in place and
tight.
• Clean bilge thoroughly if it was not done at lay-up.
• Check all engine fluid levels.
• Check fuel lines for damage and/or leaks. Make
sure that they do not come into contact with
moving parts.
SECURITY CONSIDERATIONS
Be conscious of securing your boat properly. Always
remove the keys from the ignition, lock hatches, lock
the cabin door, and remove and stow any removable
electronic gear (fishfinders, GPS, etc.) and personal
gear (fishing poles, etc.) normally left aboard your boat.
SEACOCK LUBRICATION
• Remove the hose from top of the seacock once
the boat is out of the water.
• Place seacock handle in closed position.
• Add a few drops of lubricating oil inside.
• Turn handle back and forth a few times. Add oil
as needed.
• Replace hose and tighten clamp.
• Add a few drops of oil to the handle pivot point.
OPEN
HOSE
HOSE CLAMPS
CLO
SED
SEACOCK
HANDLE
SEACOCK BODY
PIVOT POINT
Figure 9.1 Seacock