Chaparral 420 PREMIERE, Owner'S/Operator'S Manual

Page: 135 / 164

Safety Pin
The safety pin, located at the neck of the extinguish-
er bottle (Figure 8.13) in the engine room is for the
shipping and transferring of the bottle only.
The pin MUST be removed in order to manually
operate the system.
This pin should be removed upon installation of the
system. The manual system will not function unless
the safety pin has been removed from the fire extin-
guisher bottle.
Hand Held Extinguishers
As the boat owner, you are responsible for making
sure you have the required number of fire extinguish-
ers. Fire extinguishers must be approved by the U.S.
Coast Guard. Chaparral has provided a hand held
extinguisher at the helm located in the wetbar.
REFER TO OWNER’S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
REFRIGERATOR AND FREEZER
The refrigerator/freezer unit is located in the galley
aft of the galley counter. The unit is supplied power
by the REFRIGERATOR/FREEZER breaker on the
salon 120 volt AC main distribution panel and/or the
12 V DC Main Distribution Panel. To operate dock-
side, connect the shore power system; turn the
MAIN breaker(s) ON. Then turn the REFRIGERA-
TOR/FREEZER breaker on the AC and DC main
distribution panel ON.
Cockpit Ice Maker
The cockpit ice maker is located in the cockpit wet
bar (See Figure 8.11). To operate, turn ON the
COCKPIT REFRIGERATOR breaker on the salon
12 volt DC distribution panel.
To Start Ice Maker:
1. Make sure water tank is full.
2. Turn "FRESH WATER PUMP" breaker ON.
3. Turn ON ice maker switch, located at the bottom
of the unit. Allow unit to cycle several times
before using ice. Refer to water system for more
information.
REFER TO OWNER’S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
HYDRAULIC SWIM PLATFORM
The swim platform is powered through the SWIM
PLATFORM breaker located in the engine room on
the aft engine room component panel. It is operated
by the swim platform remote control unit located
inside the starboard transom locker.
To Operate Swim Platform Remote:
Plug the remote into the remote power plug, switch
ON the swim platform main switch and operate the
swim platform by depressing the desired button on
the remote.
8-11
SAFETY PIN
NOTE: THE MANUAL SYSTEM WILL NOT OPERATE
IF SAFETY PIN IS INSTALLED.
Figure 8.13 Engine Room Fire Extinguisher
WARNING: The safety pin must be removed
after cable s-hook and attachment pin are
installed. Failure to do so will result in inability
to manually operate system.