7
3. Assembly
Caution: Provide ample clearance around the trap.
DO NOT OPERATE THE TRAP IN AN AREA THAT DOES NOT ALLOW SAFE
(REAR) ACCESS TO THE TRAP AND THE ON/OFF/SAFE RELEASE SWITCH
DURING LOADING AND USE.
A. Assemble Frame
1. Assemble F1 (Axle) and F2 (Bracket Support Bar) to F11 (Mounting Bracket) using F4
(8mm x 45mm Bolt), F5 (8mm x 16mm bolt) with F6 (8mm Washers) and F7 (8mm Nut).
2. Attach F3 (Handle) to F2 (Bracket Support Bar) using F4 (8mm x 45mm Bolt) with F6 (8mm
Washers) and F7 (8mm Nut). F3 Handle end can point back or to the left as shown.
3. Assemble F8 (Plastic Wheel) to each end of F1 (Axle) with F9 (Large Axle Washer) on
each side of wheel. Install F10 (Axle Clip) in groove on each end of Axle.
F2
F1
F3
F3
F11
F8
F8
F5