11
E. Attach the Magazine
1. Slide M1 (Magazine Rod) over each magazine stud as shown.
2.
Attach M2 (Magazine Top Plate) using M3 (5mm x 10 Screws). Opening of M2 should be
toward rear of machine.
F. Setup
WARNING
: MAKE SURE THAT THE “ON-OFF-SAFE RELEASE” SWITCH IS SET TO
THE “OFF” POSITION BEFORE CONNECTING POWER TO THE TRAP.
DO NOT OPERATE THE TRAP IN AN AREA THAT DOES NOT ALLOW SAFE (REAR)
ACCESS TO THE TRAP AND THE ON/OFF/SAFE RELEASE SWITCH DURING LOADING
AND USE.
1. Connect the red battery lead to the positive (+) terminal and the black battery lead to the
negative (-) terminal of a charged deep cycle 12V battery.
2. Remove wire ties from foot pedal release cable and unwind cable as needed and place foot
pedal switch on ground.
3. For additional stability of trap, a large screwdriver or stake can be placed through rear hole
of F2 (Bracket Support Bar) and driven into the ground (see below).
Magazine Rods
Rear of Machine
Magazine Top Plate
M1
M2