![background image](http://html1.mh-extra.com/html/champion/wheelybird-40909/wheelybird-40909_instruction-manual_2588789016.webp)
14
2. Adjustments to the limit switch are made by loosening the two mounting
screws and moving the switch slightly. Pivot the switch slightly towards the
center of the trap for the arm to stop further away from the edge of the main
body. Pivot the switch slightly towards the front of the trap for the arm to stop
closer to the edge of the main body. Re-tighten the mounting screws after
adjusting the switch. Adjust switch so that a target drops onto the throwing
arm as the arm is cocking. With the on/off/safe release switch set to "on", the
tip of the arm should stop within 2.5
” to 4.5” from the edge of the top plate of
the trap. The opening in the sliding plate should line up with the opening in the
top plate and allow a target to drop.
.
Caution:
Adjusting the arm to stop at a point too
far away from the spring‟s
over-center point can result in a delayed release or improper loading and
targets breaking.
WARNING:
ADJUSTING THE ARM TO STOP AT A POINT TOO CLOSE
TO THE SPRING‟S OVER-CENTER POINT CAN RESULT IN THE ARM
CONTINUOUSLY FIRING OR FIRING UNEXPECTEDLY AND CAUSING
POTENTIAL INJURY FROM BEING STRUCK BY THE ARM.
Pivot switch this
direction to stop arm
closer to edge of top
plate
Pivot switch this
direction to stop arm
further from edge of
top plate
2.5
” – 4.5“
Slide plate
lines up with
top plate
Loosen these
2 screws