16
3. Distance Adjustment
WARNING: BEFORE MAKING ANY ADJUSTMENTS, MAKE SURE THE
THROWING ARM IS IN THE UNCOCKED POSITION, THE ON/OFF/SAFE
RELEASE SWITCH IS IN THE “OFF” POSITION, AND THE BATTERY IS
DISCONNECTED FROM THE TRAP.
THIS TRAP IS CAPABLE OF THROWING TARGETS A MAXIMUM DISTANCE
OF OVER 65 YARDS. USE ONLY IN AREAS WHERE THERE IS NO RISK OF
CAUSING DAMAGE, OR HITTING A PERSON WITH A TARGET.
Adjustment to throwing distance is made by adjusting the mainspring tension.
1. With S4 (10mm Flange Nut) fully tightened and S2 (Mainspring Bolt) tight, the
mainspring is under standard tension. The trap will throw targets a distance which
should be suitable for most users.
2. If reduced throwing distance is desired, mainspring tension can be adjusted to reduce the
throwing distance approximately 10 yards. First loosen S5 (10mm Hex Nut) and then S4
can be loosened up to a 1/2" on S2.
DO NOT EXCEED THIS AMOUNT.
3. After adjusting the spring to the desired tension, tighten S5 against S4 to lock the setting in
place. There should be a minimum of 2
1
/
4
" of S2 left exposed.
S5 S4
S2
2
1
/
4
" to 2
3
/
4
" Bolt
Exposed
Adjustment Lock
Nut