Champion UH-100, Installation Manual

Page: 12 / 84

4
Electrical Connection
Installation Guide
Electrical Connection
Main Terminal Block (MTB)
( shown pulled out of dishwasher front
to wire main incoming power)
ATTENTION ELECTRICIAN
READ THE INSTRUCTIONS BELOW
BEFORE WIRING THE DISHWASHER
Note:
Model UL100 comes with a 4 ft.
cord and plug rated for a115VAC 15A
incoming power supply
8. Connect a flexible power cord conduit to the
MTB. The power cord must extend a minimum
of 3ft out the back of the dishwasher so the
machine can be pulled out for servicing.
9. Re-install the MTB and the lower front access
panel.
L1 L2 L3 N
208-230
VAC
208-230
VAC
208-230 VAC
115VAC
GRD
(For machines
beginning with S/N 14326 and above)
THREE PHASE POWER CONNECTION
Model UH100B, UH200B and UH170B
HOW TO CONNECT 3 PHASE POWER
1. Check the data plate on the front of the
dishwasher for the phase of the machine.
.
2. Remove the lower access panel.
3. Pull power connection box forward and out.
4. The Main Terminal Block has terminals for
L1, L2, L3, Neutral and Ground.
5. Connect ground, then connect
L1, L2, L3 to 208-230VAC.
6. Connect a current carrying neutral to N.
7. Main power connections are complete.
If the data plate says the machine is 3 Phase,
then connect a 3 PH power supply.
L1 L2 L3 N
208-230
VAC
0 VAC
0 VAC
115VAC
GRD
(For machines
beginning with S/N 14326 and above)
SINGLE PHASE POWER CONNECTION
Model UH200B and UH170B
Do not connect power to L3
HOW TO CONNECT 1 PHASE POWER
1. Check the data plate on the front of the
dishwasher for the phase of the machine.
.
2. Remove the lower access panel.
3. Pull power connection box forward and out.
4. The Main Terminal Block has connections
for L1, L2, L3, Neutral and Ground.
5. Connect ground, then connect
L1, L2 to 208-230VAC.
6. Connect a current carrying neutral to N.
7. Main Power connections are complete.
If the data plate says the machine is 1 Phase,
then connect a 1 PH power supply.
DO NOT CONNECT POWER TO L3.