6
Installation
WARNING: MAKE SURE THAT THE THROWING ARM IS IN THE UNCOCKED POSITION, THE TRAP IS IN THE
OFF POSITION, THE MAINSPRING IS REMOVED, AND THE TRAP IS DISCONNECTED FROM THE BATTERY.
FOOT PEDAL MUST BE REMOVED FROM TRAP BEFORE USING REMOTE TRANSMITTER/RECEIVER TO
ACTIVATE THE TRAP.
WARNING: DO NOT MANUALLY FORCE THE THROWING ARM THROUGH THE UNCOCKED POSITION
AS THE MAIN SPRING WILL TAKE OVER AND FIRE THE TRAP, POTENTIALLY CAUSING SERIOUS
INJURY OR DEATH.
Mounting the Receiver
1. If you have not previously done so, perform a safe release, turn power off, disconnect from battery,
and empty trap magazine.
2. Screw the Receiver’s 12V Power and Output Connector male plug (
F
) onto the female 12V Power and
Output Connector on the trap.
3. Receiver should be mounted to the back of the trap, with top of Receiver flush with trap, using the
included hook and loop adhesive panel.
Programming (Pairing Receiver and Transmitter)
Before operation, the Receiver(s)
(see note below regarding controlling multiple Receivers)
will need to be
programmed to respond to the Wireless Remote Transmitter you will be using.
1. Install a 12V A23 Battery in the Wireless Remote Transmitter.
2. Receiver should be mounted and installed per “Installation” directions above.
3. Connect trap to battery and turn trap to “ON” (Trap must be turned “ON” to provide power to the
Receiver). This will arm the trap and the throwing arm will move into the cocked position. The
Receiver Status Light (C) on the Receiver will be green, indicating it is powered “ON” and will accept
a signal from the Wireless Remote Transmitter. Press and hold the Remote Learn Button (A) for 1
second to enter the learn mode. Remote Learn Light (B) will slowly flash to indicate Receiver is ready
to learn the Wireless Remote Transmitter’s signal. Press the Throw Button (G) on the Wireless Remote
Transmitter within 5 seconds for the Receiver to learn the signal. Once the Receiver has learned
the signal, the Remote Learn Light (B) will flash rapidly 3 times, confirming the Receiver has been
programmed to the Wireless Remote Transmitter.
4. Verify the Wireless Remote Transmitter and Receiver are programed by setting Throw Delay (E) to 0
seconds and press Throw Button (G). If Programming was successful the trap will fire*. If trap does
not fire when Throw Button (G) is pressed perform Programing process again or see Troubleshooting
section on next page. *
(Note: “dry firing” the trap without loading clays will not damage the unit.)
5. Perform safe release on trap and disconnect trap from 12V battery.
NOTE: Multiple receivers can be assigned to one (1) transmitter. This will allow multiple traps to be
controlled simultaneously from one remote. Use the Throw Delay knob (E) on each receiver to set the
desired delay time (0-15 sec) between traps.
WARNING: BEFORE PAIRING THE TRANSMITTER TO A NEW RECEIVER, ENSURE THAT THE BATTERY IS
DISCONNECTED ON ALL TRAPS USED WITH ANY PREVIOUSLY PAIRED RECEIVER.
Operation
1. Install Mainspring on trap.
2. Connect trap to 12V battery.
Summary of Contents for 40923
Page 15: ......
