![background image](http://html1.mh-extra.com/html/champion/40903/40903_owners-operators-manual_2588961007.webp)
6
MAKE SURE WARNINGS ON FRONT TUBE SUPPORTS
ARE UPRIGHT.
Tighten all four nuts on Tube Supports securely. Slide three
pieces of Tubing (L) over ends of Front Tube Supports (K)
and Rear Tube Supports (N-15). This ring indicates the
approximate path of the Throwing Arm (A).
TRAP ASSEMBLY INSTRUCTIONS – BASE MOUNT
STEP 1.
ATTACH TRAP BODY TO BASE (FIG 3-4)
Mount the Pivot Mount (F) to the trap base
assembly using the 12MM Hex Nut (N-2).
Orientate the pivot mount (F) so that the
serrated face of the pivot mount faces to the
right.
CAUTION: PIVOT MOUNT MUST BE
ORIENTATED IN LINE WITH THE BASE.
Tighten hex nut securely. After mounting the
Pivot Mount, mount the trap to the Pivot Mount
using the 12MM x 30MM Lg. Hex Bolt (N-1). Pivot
the trap slightly above horizontal and tighten
the hex bolt securely. This setup will provide a
good starting point for target launch direction.
Attach Trap Body Handle (O) to Trap Body using
bolt and washer on Trap Body Handle. Front of
Trap Body Handle fi ts under top of trap body
into slot and is then bolted to Trap Body.
Attach Trigger (Q) to tab on Trap Body (B) using
2 Bolts (N-20).
STEP 2.
TUBE SUPPORT ASSEMBLY (FIG 3)
Insert two 6MM X 90MM Lg. Hex Head Bolts
(N-12) through holes in the short Rear Tube
Support (N-15), through holes in sides at rear
of Trap Body (A) and through second Rear Tube
Support (N-15). Attach 6MM Flange Nuts (N-13).
IN LINE
Trap Base
Pivot Mount (F)
!
!
Trap Body (B)
Trap Body Handle (O)
Tubes
Connect
Front Tube Support (K)
6MM X 90MM
Hex Bolts
(N-12)
6MM X 90MM
Hex Bolts
(N-12)
Tubes
Connect
Arm Path Indicator Tubing (L)
Tubes
Connect
Front Tube Support (K)
6MM
Flange Nuts
(N-13)
Tubes
Connect
Rear Tube
Support (N-15)
6MM
Flange Nuts
(N-13)
Trigger (Q) &
6MM x 12MM Lg. Bolts (N-20)
Pivot
Mount (F)
12MM x 30MM
Hex Bolt
(N-1)
FIGURE 3
FIGURE 4
Trigger
Chain (N-19)
CHAMPION
TRAPS & TARGETS
SKYBIRD
WARNING
AT
ALL
TIM
ES!
SE
IOU
S INJ
UR
Y M
AY
RES
ULT
.
STA
Y C
LEA
R O
F T
HR
OW
ING
ARM
6mm x 24mm
Hex Bolt &
M6 x 18mm
Washer
(N-21 & N-22)
12MM Hex Nut
(N-2)
Tubes
Connect
Summary of Contents for 40903
Page 2: ...ENGLISH FRAN AIS 2 13 14 25...
Page 27: ......