Challenge Titan 265, Instruction Manual

Page: 23 / 88

6.0 Operation
22
Figure 15
Figure 16
6.6 Knife Change Alarm and Lubrication Alarm
The Titan 265 has two built in alarms that will be displayed after a certain number of cuts. The knife
alarm displays a message to remind the operator to change the knife. The lube alarm displays a
message to remind the operator to have the machine lubricated. The lube alarm will also display the
name and phone number of the Challenge dealer from which the machine was purchased. To reset
either alarm, or to change the knife alarm value, see the Knife Count section on page 27. The lube
alarm value is factory set at 2,500 cuts and cannot be changed. NOTE: The alarms do not prevent
normal operation; they are simply reminders.
6.7 Manual Clamping (Using the Foot Treadle)
The Titan 265 is equipped with a manual clamping feature, which allows the operator to manually
clamp paper before beginning the cut cycle. To use this feature, press down on the foot treadle until
the clamp comes down on the paper. While holding the foot treadle down, if equipped close the
guard and press the cut button. Release the foot treadle once the cut has been completed.