Challenge Titan 265, Instruction Manual

Page: 21 / 88

6.0 Operation
20
6.0 Operation
IMPORTANT: DO NOT ATTEMPT TO OPERATE THE CUTTER UNTIL YOU HAVE THOROUGHLY
READ AND UNDERSTAND ALL OF THE FOLLOWING INSTRUCTIONS. CALL YOUR
AUTHORIZED CHALLENGE DEALER IF YOU STILL HAVE ANY QUESTIONS.
6.1 Power – Main Switch
Power is brought to the machine when the main power switch is turned to the “ON” position (Figure
14). The display and line lights are turned on at this time.
Figure 14
The display and line lights will shut off after 5 minutes without any activity. This shut-off time can be
changed in the Parameters screen of the Maintenance Mode section on page 26. To restore power
to the display and line lights, press any button on the keyboard, or press any cut button, or lift up the
front guard (if equipped).
6.2 Start Up
Once power has been turned on, the Titan 265 will show the following display:
When the CLEAR key is pressed the clamp and knife will move up if they are not already in the up
position (provided the front guard is closed, if equipped). Then the backgauge will move to
coordinate the true position into the computer. When finished, the machine will be in “Send Mode”
and the display will appear similar to the display shown on page 21.
OFF ON
55.000
in
Backgauge must move to be
preset. Please clear the table and
close guard.
Warning! Clamp and Knife may
move.
Revision x.x
Press clear to start
A) Maint
B) Job