1
3
2
4
FIGURE 14
Honda Engine Shown
1. Throttle Cable
2. Throttle Bracket
3. Cable Stop
4. Throttle Stop Screw
18. Move throttle control on control panel to low idle
speed
position while inserting cable end through
19. Rotate engine throttle to high idle speed position.
Tighten cable screw to secure cable.
DO NOT
overtighten cable stop.
20. Pull throttle control on panel back to low idle, then
push back to high dile.
21. If the engine throttle lever is not contacting the end of
the throttle stop screw, the cable stop must be
loosened and the throttle cable wire pulled through the
cable stop further.
22. Reinstall throttle cover. Secure with two original
10mm screws.
23. Use wire ties to secure convoluted tubing to handle-
bar support. See Figure 15.
1
5165
FIGURE 15
1. Wire Ties
24. Clutch control lever should line up with console corner.
Adjust brake band by turning the adjusting
screw at bottom of brake band with an allen wrench.
Adjustment should be snug enough but not too tight
to cause smoking of the drive belt. Install the locking
nut to hold the brake band adjustment in place.
25. If brake band cannot be adjusted, reposition engine.
Slots on engine plate should be showing 7/32” to
1/4”. See Figure 16.
5175
FIGURE 16
26. Install one (1) 1/2–13 flangelock nut (flange side
towards the outside of the unit) onto the guard sup-
port rod before guard is reinstalled.
27. Reinstall guard onto side of unit using original hard-
ware. Secure “L” bracket to guard using new hard-
ware.
NOTICE
All vehicles operated outside the U.K. in the Euro-
pean community do not apply an operator instruction
decal.
28. In North America and the United Kingdom apply the
operator instruction decal. See following illustration.
29. Insert the two (2) 15 1/2” (394 mm) cable ties through
the holes in the literature mounting plate (See Fig.
17). Secure literature tube using the cable ties.
8
17. For Honda engines route throttle cable through
throttle bracket as shown in Figure 14. The cable end
shoulder should be positioned as shown against the
end of the throttle bracket. Tighten down throttle
bracket making sure not to overtighten.
cable stop.
Move throttle control to high idle speed.
Summary of Contents for RYAN JR SODCUTTER 544844E
Page 28: ...SPANISH 26...
Page 67: ...SWEDISH 65...
