1
FIGURE 17
1. Literature Mounting Plate
30. Attach the cutting blade using six (6) 5/16–24 x 1”
grade 8 screws, lockwashers and nuts. Torque at-
taching hardware to 30 ft.–lbs. (40.7 N
⋅
m).
NOTICE
Use only the special grade 8 cap screws provided.
Screws below grade 8 will not withstand the recom-
mended torque requirements.
31. Attach throttle control cable to handle using clip
(loose on cable), one (1) #10–24 x 1/2” screw and
lockwasher.
32. Install one (1) 1/2” flangelock nut to the guard sup-
port rod.
CONTROLS
Engine Switch
Turn to “ON” position to start
engine. Turn to “OFF” position
to stop engine.
Clutch Control
Engages or releases drive belt
Lever
and applies brake action to
drive belt when pulled FIRMLY
to rear. See Figure 18, item 1.
Throttle Control
Speeds up or slows down
engine. See Figure 18, item 2.
Operator Presence
With clutch control engaged,
Control
engine will stop if operator
presence
lever
is
not
depressed.
See Figure 18, item 3.
4901
FIGURE 18
1. Clutch Control Lever
2. Throttle Control
3. Operator Presence Control
Blade Depth
Raises or lowers cutting blade.
Control Lever
See Figure 19, item 1.
Blade Angle
Adjusts cutting angle of blade.
Locking Lever
See Figure 19, item 3.
Blade Depth
Locking lever holds blade
Control Locking
depth control lever in desired
Lever
position. See Figure 19, item 2.
Depth Gauge
Allows resetting of blade depth
to the previous cutting height.
1
2
4
4900
3
FIGURE 19
1. Blade Depth Control Lever
2. Blade Depth Control Locking Lever
3. Blade Angle Control Locking Lever
4. Depth Gauge
9
3
1
2
Summary of Contents for RYAN JR SODCUTTER 544844E
Page 28: ...SPANISH 26...
Page 67: ...SWEDISH 65...
