CFR 10416A, Instruction Manual

Page: 9 / 24

CFR CASCADE
9
Operating the Cascade
P20SP – The easy to use, self-propelled Cascade cleans
in the forward direction. The speed dial allows the operator
to select the appropriate speed for the area to be cleaned.
The slower you drive the machine the deeper the cleaning.
Machine cleaning performance can be monitored visually
through the tank lid.
1. Prior to cleaning you will need to be sure the pump
is well primed.
• Turn speed dial to 0 (zero).
• lower the floor tool.
• Turn vacuum switch on.
• Turn pump switch on.
• Squeeze the trigger for 30 seconds.
• Adjust p.s.i. from 0 to 400, if necessary.
Note: For P20 OZ models, turn on vacuum, pump and
ozone switches on and let machine run for 15 minutes
before use.
P20 – The easy to use wand system cleans in the forward
direction.
1. Prior to cleaning, purge the air in the solution line by
circulating solution into the tank through the hose.
• Attach hose and solution line without tool attached
and place hose end in tank opening
• Turn pump switch on and engage trigger for
30 seconds.
• Adjust p.s.i. from 0 to 400, if necessary.
This primes the pump, purges air from the lines, and
automatically mixes the chemicals. The Cascade P20 is
ready for cleaning. Note: If priming does not work, refer
to page 16.