CFR 10416A, Instruction Manual

Page: 12 / 24

CFR CASCADE
12
Tool Head
The P20 is designed to be tilted back
for easy access to the tool head and
underside of machine.
Warning: Never tilt machine back
when tank contains solution.
1. lower the tool head.
2. Disconnect the vacuum hose.
3. Disconnect and remove the tool head.
A. Disconnect the solution hose.
B. Remove the two quick release tool pins.
C. Unscrew the two thumbscrews from each side of the
tool head and slide the tool head off.
4. Remove the spray bar and rinse.
5. Visually inspect quick disconnect spray tips
for blockage.
6. Open and clean the in-line strainer filter and replace.
• Disconnect the in-line strainer filter by using the
quick disconnect coupler.
• Remove any debris from the strainer.
• Keep o-ring and threads of the plug lubricated.
CFR DEFOAM is a good lubricant or use a
non-petroleum based lubricant. This will ensure a
tighter seal.
7. Remove any large debris from underneath the tool
head. Rinse the vacuum chamber on the tool head.
8. Replace spray bar.
9. Connect the tool head.
• Connect the solution hose.
• Replace the two quick release tool pins.
• Replace the two thumbscrews from each side of
the tool head.
10. Connect the vacuum hose.
11. Raise the tool head for storage.
B
C
4
6
A
Spray tips
Spray bar
In-line strainer
Vacuum chamber