CF MOTO CF400-A 2017, Service Manual

Page: 380 / 443

16-12
CFMOTO
Initial Charge
●
Place the strip [A] of caps loosely over the filler
ports.
●
Newly activated sealed batteries require an initial
charge
.
Standard Charge
:1.2A X5-10h
Battery
Charging rates will vary depending on how long the
battery has been stored, temperature, and the type
of charger used. Let battery sit 30 minutes after
initial charge, then check voltage using a voltmeter.
If it is not at least 12.8 V, repeat charging cycle.
.
●
After charging is completed, press down firmly with
both hands to seat the strip of caps [A] into the bat-
tery (don
’
t pound or hammer.). When properly
installed, the strip of the caps will be level with the
top of the battery.
Once the strip of the caps [A] is installed onto
the battery, never remove the caps, nor add
water or electrolyte to the battery.
To ensure maximum battery life and customer
satisfaction, it is recommended the battery be load
tested at three times its amp-hour rating for 15
seconds. Recheck voltage and if less than 12.8 V
repeat the charging cycle and load test. If still be
low 12.8 V the battery is defective.
CAUTION
NOTE