18
OPERATING INSTRUCTIONS.
NAILER CONFIGURATION:
1.
Safety nozzle
2.
Latch
3.
Air entrance
4.
Air deflector
5.
Trigger
BE SURE NOT TO OBSTRUCT THE AIR DEFLECTOR.
NAIL LOADING:
1.
Pull the latch and pull the moving drum back, out of the fixed drum.
2.
Insert the load of nails into the moving drum.
3.
After the nails are loaded, slide the moving drum back into the fixed drum until the latch
clicks into place, closing the moving drum.
PERFORMING THE WORK:
1.
Establish a work area that is clean and well lit. Do not allow children or pets access to the
work area, to avoid distractions and injuries.
2.
Connect the pressurized air hose and extend it along a safe route to reach the work area
without creating a risk of tripping or exposing the hose to possible damage. The hose must
be long enough to comfortably reach the work area and allow free movement within the
area.
3.
Secure loose workpieces using a vise or clamps (not included) to prevent movement during
work.
4.
There should be no dangerous objects nearby (such as utility lines or foreign objects) that
could pose a danger during work.
5.
If an automatic lubricator is not used, add a few drops of pneumatic tool oil before use. Add
a few more drops after each hour of continuous use.
6.
Install nails correctly, lock drum after loading.
7.
Keep the second hand out of the nailer's discharge area, especially if you hold the
workpiece.
8.
Do not hold the Nailer close to your body while firing. Kickback of the tool can cause injury.
9.
Place the Nailer in the desired position and fully press the safety nozzle against the
workpiece. Squeeze the trigger to fire the charge.
EN
