#HI6133
Windshield
Leave the protective coating in place until after it is drilled
for mounting screws. Rough cut the windshield leaving 3mm
[1/8”] then carefully cut out the windshield following the
line molded into the winshield.
Position the windshield and tape in place. Mark and drill
pilot holes around the windshield edge, centered through the
matching recess of the canopy.
#HI6130 Fiberglass
Gelcoat Canopy
Drill 8-9 holes.
Bond the wood inside mounts into the inside of the canopy
with Epoxy. Center each block over the holes with the top
edge flush to the canopy edge. Once cured, drill the final
hole size for the screws.
#HW6125
Wood inside
mounts
Flush to canopy
edge.
Clean the canopy. Trim the decals from the sheet and apply
to the side of the canopy before the lower grommet is
installed. Cut through the decal and install the lower grom-
met through the canopy.
#HI6131 Decal
Sheet
#HW6125
Rubber
Grommets x 4
Install lower
grommet after the
decal is applied.
M3x6 Self Tap
Screws x 10
Attach the windshield with the M3 self tapping screws
being careful not to overtighten them.
After the canopy is finished, the wooden blocks can be
painted white to match the canopy. The rubber grommets
should be reinforced using “Goop” adhesive or similar.
Reinforce the
rubber gromments
on the inside using
“Goop” adhesive.
60/70 SE &
Max 90
Decal Locations
1.
8.
Lower cheek of canopy.
2.
7.
Middle, below windshield.
3.
6.
From edge below rear grommet
4.
10.
Horizontal Fin (top & bottom on 60/70).
5.
9.
Vertical Fin (above & below on 60/70).
97
98
102
100
19
99
101
