Insert the M2 threaded rod 10mm into the grey ball link.
Slide the end cap over the carbon tube and make a mark,
remove and sand the carbon up to this mark for better
adhesion. Using JB Weld or Epoxy bond in place. Only
complete one end at this time. Thread the ball link into the
end cap until it stops using threadlock.
#HW6065 Tail
Pushrod Set
Insert 10mm into
grey ball link.
End Cap
Only
complete
one end
now!
SE & Max 90 only.
Insert and mark each end of the carbon struts where the strut
fittings will overlap. Remove and sand down each carbon
end until they slide easily into the fittings. Scratch inside the
fittings also. Using JB Weld or Epoxy, bond the fittings in
place. Make sure each strut has the fittings 90
0
degrees to
each other.
#HW6202A Carbon
Support Struts x 2
#HI6080 Tail
Servo Mount
Set
Install the rudder servo into the tail rudder servo mounts
using M2.5 self tapping screws inserted through the top of
the servo grommets into the vertical mounts.
M2.5x12 Self
Tapping
Screw x 4
Wrap the tail mount liners around the tail boom and trim if
necessary. Install the rudder servo mount assembly onto the
tail boom, over the liners and secure using the M2.5 socket
screws. Leave these loose until after the tail pushrod has
been attached. Attach the rudder servo horn, positioning the
steel ball at 12-14mm from the servo center.
M2.5x12
Socket
Screw x 2
M2.5x12 Socket
Screw x 2
60/70 only.
#HI6067 Tail Fin Set -
Horizontal & Vertical
Install the decals for the fins at this time.
#HI6080 Tail
Mount Liner x 2
The Aluminum support struts are ready for installation.
#HW6202
Tail Support
Strut Set -
Aluminum
60/70 only.
79
80
81
16
83
84
82
