Press the M4 bearing into the end, slide the M3 thrust
bearing (in correct order), micro washer, M3 bearing and
locknut from inside the grip. Use locktight on the locknut.
#HW3098A Steel
Tail Rotor Hub
#CNBB410 x 2
#HI3096A Tail
Grips x 2
#CNLR1013 x 2 Short Steel Ball
#CNBB49T x 2
#CNBB0930
x 2
#CNLR1003 M3x5x0.5
Micro Washer
M3 Locknut x 2
Insert tail rotor grip assembly onto the tail output shaft,
aligning the set screw over the indent in the shaft using
locktight. Attach the tail pitch ball links to the balls, the steel
ball is on the leading edge of the blades.
M3x4 Set Screw
Tail rotor
assembly
Tail rotor blades are installed with the leading edge rotating
upwards into the downwash of the main blades. Looking at
the left side of the Predator, the blades turn clockwise with
the steel ball on the leading edge.
#CN260956 Rotortech 95mm Tail Blades - SE
#CN261056 Rotortech 105mm Tail Blades - Max 90
#HI6099 Tail Rotor
Blades - 60/70
#HW6001 M3x18 Shoulder
Socket Screw x 2
M3x10x1.5
Spacers x 4
M3 Locknut x 2
The carbon tail blades will not fit the tail rotor grips without
trimming the ends. Attach the two blades together and grind
3-4mm off the end of the blades as shown.
Bolt both blades
together.
Grind 3-4mm
off end.
Install the tail rotor blades to the tail rotor grips with the M3
shoulder socket cap screws, M3 spacers on both sides the the
blades and secured with M3 locknuts, fitted into the molded
recess on the tail blade grips.
Completed tail
gearbox assembly.
Locknuts
face
outside.
Insert the front of the tail boom into the front tail transmis-
sion half and close the transmission. Secure with M3 socket
screws locknuts. Attach the tail boom assembly to the
mechanics with M3x8 screws first then the Flat head screws.
Attach first, then remove and locktight all the screws.
M3x10 Flat Head
Screw x 2
M3x8 Socket Screw x 4
M3x12 Socket
Screw x 4
& M3 Lock-
nut x 4
#CNLR1014
Short Steel
Ball
74
15
73
75
76
77
78
