#HI3176C Flybar
Control Yoke
Assemble each flybar control arm half before it is installed by
threading the double studded ball into the end of the tapered
end of the control arm.
Pushrod A
47mm (center
to center)
M3x12
Button Head
Screw
M4x6
Washer
M4x5 Set
Screw
#HW6180A
Feathering Spindle
#HI6184
Main Blade Grip
#CNBB815T
M5x10 Socket
Screw & M5
Flat Washer
Slide one large shim against the o-rings followed by three
shims onto the feathering spindle, followed by the blade grip
assembly. Pitch arm is on leading edge. Grease and install the
thrust bearings and secure with the M5x10 socket screw and
washer using threadlock.
#CNBB816
M14 Thrust
Washer
Insert one ball bearing into each end of the main blade grip.
Slide the M14 Thrust Washer against the inside bearing.
Assemble the flybar, paddles and flybar yoke around the rotor
head and secure with the M4x5 set screws attached from the
top of the arms using threadlock.Adjust pushrod and attach to
from the seesaw to the medium ball on the adjustable side of
the bell mixer.
Bell mixer
assembly
Flybar Yoke
Assembly
#HW6173 Flybar
HI6179
20gr 3D
Grey
SE-Max
HI6179A 30gr Sport Black 60
Pushrod B
26mm (center to
center)
9.0:1
60 & SE
4
9.3:1
3
8.18:1
Max
1
8.45:1
Max
0
Gear Ratio Kit # Shims
M4x16 Socket
Screw
#HW6017
Engine Mount
Shims x 8
Before installing the engine, check the gear ratio to determine
the correct number of shims to install between the mounting
lugs on the engine and the engine mount.
Attach the seesaw assembly with one M3x18 special socket
screw threaded into the blade grip. Be careful not to over-
tighten the screw.
M3x18 Special Socket
Shoulder Screw
#HW6001
#CNLR1014
Short Ball
#CNLR1020
Medium
Ball
#HI6181
Damping
Shims
7
8
9
12
11
10
4
