Install throttle servo to the right side frames. Attach the short
ball with M2 thread to the carburetor lever arm with M2 nut
and the short steel ball to the top side of the servo arm at
13.5mm. Ensure the 90 degree angle from the pushrod to the
servo and carburetor arm for linear setup at midstick.
Parallel
Parallel
Pushrod E 100mm
(center to center)
Pushrod F
116mm (center
to center)
#CNLR1018 Ultra
Short Steel Ball
Optional metal
servo arms
shown.
The double bearing swashplate requires no maintenance. If a
steel ball needs changing, insert the 2.5 hex key through one
of the extra holes in the outside ring. Two medium ball on the
inside race.
#HI6146 Swashplate
Assembly
#CNLR1014 Short
Steel Ball x 5
#CNLR1019 Long
Steel Ball x 2
Pushrod G 56.5mm
(center to center) x 2
Parallel
Install the swashplate on the main shaft and connect to the
rear and front ccpm pushrods. Trim the radio to level the
swashplate, set to 90 degrees to the main shaft.
90
0
#HI3152C Washout
Assembly
#HI3152A
Radius Link
& Pin
M3x16
Button Head
Screw x 2
#CNBB37 x 4
#CNLR1020
Medium Steel
Ball x 2
The washout unit comes assembled. Slide onto the main shaft
and ensure that the screw is on the left side of the main shaft.
M3x5x0.5
Micro Washer
x 2
Slide the washout guide and align the washout pins with the
washout guide. Attach the rotor head with M4 socket head
cap screw and M4 locknut. Insert the M3 set screws and
position the guide with the screws aligned to the slot in the
head block.
Pushrod A
47mm (center
to center) x 2
M4x22 Shoulder
Socket Screw &
M4 Locknut
M3x4 Set
Screw x 2
Pushrod C
102mm (center
to center) x 2
Attach pushrod C from the long ball on the inside race of the
swashplate to the single ball (non adjustable) on the bell-
hiller mixing arms. These pushrod lengths are starting points,
adjustment is necessary for the particular style of flying.
#HW6192A
Lower Linkage
Set (8 rods)
#HI6145 Ball Link Set
(26 long & 4 short)
Pushrod B
26mm (center
to center) x 2
M3x5x3 Steel
Spacer x 2
56
58
12
55
57
59
60
