15
4.7) Errors/Malfunctions
These appear on the display during operation, combined with a beep to notify the operator of
procedural or operational errors.
Message
Error description
S
olution
In crimping mode:
the pressure re-
lease button (12) was pressed before
the control parameters were reached
(Force/Pressure).
Repeat the work cycle and wait for the motor
to stop automatically.
Interruption of the signal from
the NTC temperature probe of the
battery.
Replace the battery.
If the problem persists, please contact
Cembre
.
Interruption of the signal from
the NTC temperature probe of the
battery.
Replace the battery.
If the problem persists, please contact
Cembre
.
Abnormal power consumption of
the motor.
The tool stops.
Wait for the display to turn off (60 sec.) or remove
and re-insert the battery, then re-start the tool.
If the error occurs frequently, contact
Cembre
.
Output voltage of the pressure trans-
mitter is out of the pre-set range. The
tool stops.
Repeat the work cycle.
If the error occurs frequently, contact
Cembre
.
Failure to reach the set pressure
within 30 sec. of continuous opera-
tion of the tool. The tool stops.
Repeat the work cycle.
If the error occurs frequently, contact
Cembre
.
Overcharging of the battery with
protection tripping.
The tool stops.
Wait for the display to turn off (60 sec.) or remove
and re-insert the battery, then re-start the tool.
If the error occurs frequently, contact
Cembre
.
Errors 00.. are displayed for about 30 seconds before being reset, but will display re peat-
edly in the event of permanent anomalies.
5. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with
the following points, should help to maintain its optimum performance:
5.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any residue,
especially close to pivots and moveable parts.
Do not use hydrocarbons to clean the rubber parts.
5.2) Storage case
When not in use, to protect the tool from accidental damage and dust, it should be stored with
its accessories in the special canvas bag or plastic case supplied and sealed well.
B540NDA
and
B540NDK
provided with
CVB-033
canvas bag, size 740x215x200 mm (29.1x8.5x7.9
inches), weight 1,7 kg (3.7 lbs) .
B540ND
provided with
VAL-P60
plastic case, size 620x360x138 mm (24.4x14.2x5.4 inches), weight
2,4 kg (5.3 lbs).
ERROR
Ï
Ð
001
Ï
Ð
002
Ï
Ð
003
Ï
Ð
004
Ï
Ð
NTC
FAULT
NTC
FAULT
