13
(*) Screens 1-2-3-4-5-6-7 can be set as the “main screen” which is
shown on the display at every use of the tool. To do this, when the
pre-selected screen is displayed, hold the fi nger on the button (11)
until a confi rmation “beep” is heard.
4.2) Choosing the "operating mode"
The “operating mode” allows the user to set the tool depending on the type of jaw mounted. This
enables the optimisation of the job cycle and charging of the battery.
It is possible to choose between two diff erent operating modes:
Operating
mode
Associated
pictogram
Function
CRIMPING
factory setting
Specifi cally for using the tool with crimping jaws (CDD6N, CDD6-
6N, CDD6-8N) for crimping of electrical connectors.
CUTTING
Specifi cally for using the tool with cutting jaws (CMB4N, CMB5N,
CMB6N) for cutting electrical conductors and steel ropes.
To change the desired “operating mode”, proceed as follows:
- Select screen 8 from the “main menu” (Ref. to
section 4.1
).
- Hold the finger on the button (11) until a confirmation “beep” is heard, the choice made is shown
by filling of the related pictogram.
4.3) Choosing the "release mode"
The phase of discharging the oil into the tool’s tank can be carried out in two diff erent ways,
depending on the mode set in the menu:
Release
mode
Associated
pictogram
Function
SMART
factory setting
By releasing the operating button (3) the oil is returned in full to
the tool reservoir only following automatic shut-off of the motor.
During the return phase, pressing the buttons enables the ram
stroke to be interrupted at any point so as to be able to restart from
this position in the next work phase, thus saving time and energy.
MANUAL
To return the oil to the tool reservoir it is necessary to press and
hold the release button (12).
During the return phase, by releasing the button it is possible for
head ram stroke to be interrupted at any point so as to be able
to restart from this position in the next work phase, thus saving
time and energy.
BEEP
2
BEEP
2
