14
To change the "release mode", proceed as follows:
- Select screen 9 from the “main menu” (Ref. to
section 4.1
).
- Hold the finger on the button (11) until a confirmation “beep” is heard. The choice made is shown
by positioning of the cursor under the pictogram.
4.4) Enabling/disabling the LED Worklights
(factory setting is LED ON)
Select screen 10 from the “main menu”
(Ref. to
section 4.1
). To deactivate or re-
activate operation of the LED Worklights,
hold the finger on the button (11) until a
confirmation “beep” is heard.
4.5) Return to original factory settings / fi rmware version
Select screen 11 from the “main menu” (Ref. to
section 4.1
). To return the tool to its factory settings,
hold the finger on the button (11) until a confirmation “beep” is heard.
The RESET screen also shows the fi rmware version of the control board.
4.6) Alarms/Warnings
These appear on the display during operation and inform the operator on the state of the tool.
Message
Meaning
Description
BATTERY
LOW
Replace or recharge the battery.
NOTE: when the battery voltage falls below a minimum safety
threshold,
the tool will not start
, although it is still possible to
end the work cycle in progress.
BATTERY
TEMPERATURE
HIGH
Remove the battery and wait until it cools down.
In order to cool quicker, it is possible to insert it into the supplied
battery charger supplied, thus making use of the specifi c “AIR
COOLED” function.
REQUEST
MAINTENANCE
No. of cycles to recommended maintenance is reached. The tool
continues to work however, it is recommended that it is sent to
Cembre
for a complete overhaul (Ref. to section 7).
NOTE: this message, will reappear when the tool has been idle
for 30 s.
BATTERY
Ï
Ð
BATTERY
Ï Ð
30001
3
Ð
LED
OFF
LED
ON
LED
OFF
LED
ON
BEEP
2
RESET
SW:S1J96900
