Series VC-50 / SVC-50 / MVC-50 / LVC-50
49-MCVC50EN03
2
USER´S MANUAL
3. INSTALATION
3.1. GENERAL INSTALATION
The platform should be placed on a firm, even surface.
Avoid extreme temperatures. Do not place the scales in direct sunlight or near air conditioning vents.
Avoid unstable tables. The tables and the ground should be firm and not vibrate. Do not place the platforms
near vibrating machinery.
Avoid unstable electricity sockets. Do not use the scales near equipment with high electrical power
consumption such as soldering equipment or large motors.
Avoid draughts such as those from fans or open doors. Do not place the scales near open windows.
Keep the indicators and the platforms clean and dry.
These indicators and platforms do not have a waterproof design (IP44) and therefore high levels of humidity
should be avoided since this can cause condensation. Avoid direct contact with water. Do not spray water on
the scales or submerge them in water. If the scales come into contact with water, measurements may
become unstable or the scales may not operate correctly. Please unplug the scales immediately from the
power supply.
Do not stack anything on the scales when they are not in use.
3.2. INSTALLATION OF SERIES SVC-50 / MVC-50 / LVC-50
The column is attached to the base by means of a bracket that should first be secured to the body of the
base using the 4 screws supplied. The column is attached to the bracket with 2 pressure screws. The cable
that runs from the indicator module base travels inside the tube and comes out of the plastic support at the
top. Any surplus cable can be stored inside the tube.
Series SVC-50 / MVC-50 / LVC-50 comes with a stainless steel platform that is packed separately. Place the
platform on the base.
Ensure the scales are standing level, by adjusting the four feet. Adjust the scales so that the bubble in the
vial is in the centre and the scales are resting on all four feet. If the scales wobble, readjust the feet.
Place the indicator module on the column by sliding it over the bracket, and securing the edges in the base
slots. Position the cable that is in the socket base situated at the back of the indicator.
Plug in the power supply cable in the socket situated at the back of the indicator.
Make a weight calibration as shown in paragraph 9 (Calibration)