CEA TREO 1800 Synergic MIG-MAG, Operator'S Manual

Page: 41 / 42

19
Error
condition
Error
code
Error description and possible
diagnosis
Err E1.1
USER FILE MISSING
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E1.3
CALIBRATION FILE MISSING
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E1.6
MMA DEFAULTS MISSING
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E1.7
TIG DEFAULTS MISSING
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E1.8
MIG DEFAULTS MISSING
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E1.9
WELDER DEFAULTS MISSING
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E2.0
FILE SYSTEM ERROR
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E3.2
STICKING
This error is displayed when a
shortcircuit has been formed
between the machine’s output
terminals for more than 1.2 seconds.
NON automatic reset error.
To remove the error state, eliminate
the short circuit so that the voltage
on the torch goes above the
threshold value again. At this stage
the error condition disappears and
the welding machine goes back to
the mode prior to the sticking. If the
torch trigger is still pushed, it must be
released and pressed again to begin
welding again.
Err E4.0
LAST SETUP NOT VALID
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E4.1
JOBS WRONG
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E4.2
MIG SYN SPECIAL FUNCTION “Fx”
WRONG
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E4.3
MIG MAN SPECIAL FUNCTION “Fx”
WRONG
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E5.0
MIG PROGRAMS MISSING
NON automatic reset error.
Immediately contact technical
assistance dept.
Err E5.3
MMA PROGRAMS MISSING
NON automatic reset error.
Immediately contact technical
assistance dept.
(continued)
Error
condition
Error
code
Error description and possible
diagnosis
AUT ADJ
POWER LIMITATION
This alarm appears if the power limit
is exceeded. The alarm alternates
with the standard display every 1.5
seconds, despite which the machine
continues to weld, supplying limited
power, but complying with the values
shown on the data plate.
The table includes 2 types of errors:
• Automatic reset error: Once the alarm condition has been re-
solved the welding machine starts working again and the ope-
rator can weld again!
• NON automatic reset error: To remove the alarm status
and reinstate correct operation of the machine, the welding
equipment must be switched off. The machine will then be wor-
king again and the operator can weld again!
PLEASE NOTE: If, when switching on, the error status pre-
sents itself again, immediately contact the Technical Assi-
stance Department.
This is necessary so that our technical assistance dept ( that
must be contacted each time the error messages appear on
the welding machine’s operator interface ) is able to resolve
the problems more easily and as quickly as possible, thanks to
the reports by the user, and also because, in the meantime the
welding machine does not allow the operator to do their work.