CEA TREO 1800 Synergic MIG-MAG, Operator'S Manual

Page: 39 / 42

17
To interrupt the HOLD function and go back to the PRESETTING
phase before 15 seconds have passed, simply turn one of the two
ENCODER (E1-E2) knobs.
E1 E2
The HOLD function can be terminated ahead of time even once
again starting the welding.
Once 15 seconds have passed (HOLD FUNCTION) the TX con-
trol panel goes back to the PRESETTING phase.
JOB
1 - CREATING AND SAVING A JOB
This operation makes it possible (during MIG-MAG, MMA, and TIG
welding processes) to create and save welding settings (points)
that can be called up by the operator at any time. The TX control
panel provides the possibility of saving a total of 99 JOBS spread
over all the welding processes. There are not limits to the quan-
tity or position of the points that can be saved for each process!
When it leaves the factory the welding machine does not have any
JOBS saved in it and so the operator will find the TX control pa-
nel in this condition:
Having defined the parameters the operator needs to do their work
correctly, they can be saved by creating an AUTOMATIC WEL-
DING POINT (JOB), proceeding as follows:
1) Hold the SAVE “MEM” key (T2) down for at least 3 consecuti-
ve seconds until both displays show the flashing wording that
represent the first AUTOMATIC WELDING POINT (JOB) free
and/or available to the operator that can be used for saving
the data (e.g.: A01 ).
T2
To be able to choose another automatic welding point (JOB)
that is free for saving the data, simply turn one of the two EN-
CODER (E1-E2) knobs until you reach the required point.
E1 E2
WARNING: If all the automatic welding points (JOBS) are occu-
pied, the check automatically goes to the first automatic welding
point (JOB A01) as shown in the figure below).
3) Keeping pressed, for at least 3 consecutive seconds, the
SAVE “MEM” Key (T2), the JOB is memorised and the TX
panel loaded, automatically, the settings / parameters (spe-
cial functions included) of the JOB just saved.
4) To exit the JOB, press and release the WELDING PROCESS
SELECTION key (T2).
T2
2 - JOB SELECTION
Select the JOB, pressing and releasing, even various times if ne-
cessary, the WELDING PROCESS SELECTION key (T2) until the
corresponding LED lights up.
T2
3 - PRE-SETTING / VIEWING MEMORISED JOB DATA
Since the parameters are memorised, within each JOB, viewa-
ble but not modifiable, the pre-setting phase does not exist, but
the operator can see and verify the settings, previously saved
and memorised, pressing and releasing the PARAMETER SE-
LECTION key - A (T1) or in alternative the PARAMETER SELEC-
TION key - V (T4).
The SPECIAL FUNCTIONS “Fx” Key (T3) of “first level” contai-
ned within each individual JOB can be viewed (but not modified)
by simply keeping the SPECIAL FUNCTIONS “Fx” key (T3) pres-
sed for a duration of about 3 seconds.
The display of the parameters (special functions included) lasts
only a few seconds, then the panel shows, in an automatic way,
the previous working condition.
T1 T4
T3