CEA TREO 1800 Synergic MIG-MAG, Operator'S Manual

Page: 24 / 42

2
ENGLISH
EN
Introduction 2
Control panel 3
KEY AND KNOB COMMANDS 3
DISPLAY AND LED INDICATIONS 4
Switching on the welding
machine and initial screen 4
Viewing the software version installed 4
Loading of the wire 5
Special functions “Fx” 5
Special Functions Menu (SPC FnC) 7
PROCESS DEFAULT (dEF) 7
FACTORY DEFAULT (FAC) 7
SAFETY CALIBRATION CODE (SCC) 8
MOTOR CALIBRATION (CAL) 8
MIG-MAG synergic 9
1 - WELDING PROCESS SELECTION 9
2 - SELECTION OF WELDING PROGRAMME 9
3 - WELDING MODE SELECTION 9
4 - SPECIAL FUNCTIONS “Fx” SELECTION 10
5 - PRE-SETTING 10
6 - WELDING 11
7 - HOLD 11
MIG-MAG manual 11
1 - WELDING PROCESS SELECTION 11
2 - WELDING MODE SELECTION 11
3 - SPECIAL FUNCTIONS “Fx” SELECTION 12
4 - PRE-SETTING 12
5 - WELDING 13
6 - HOLD 13
Introduction
This manual describes the functions and the manner of utilisation
of the TX 18 control panel mounted on the TREO 1800 synergic
welder.
Electrode (MMA) 13
1 - WELDING PROCESS SELECTION 13
2 - SELECTION OF WELDING PROGRAM 14
3 - SPECIAL FUNCTIONS “Fx” SELECTION 14
4 - PRE-SETTING 14
5 - WELDING 14
6 - HOLD 15
7 - ACTIVATING THE VRD DEVICE 15
TIG with “Lift” striking 16
1 - WELDING PROCESS SELECTION 16
2 - SPECIAL FUNCTIONS “Fx” SELECTION 16
3 - PRE-SETTING 16
4 - WELDING 16
5 - HOLD 16
JOB 17
1 - CREATING AND SAVING A JOB 17
2 - JOB SELECTION 17
3 - PRE-SETTING / VIEWING MEMORISED JOB
DATA 17
4 - WELDING 18
5 - HOLD 18
6 - MODIFICATION AND OVERWRITING OF A
MEMORISED JOB
18
7 - DELETING A JOB SAVED 18
Error condition 18