EN
EN
DIGIWAY Plus
Inward or Outward Door Operator
37
Follow the Door CALIBRATION procedure, corresponding to STEP III, described on page
Follow the Door CALIBRATION procedure, corresponding to STEP III, described on page
22 of this manual, up to the end. The door remains OPEN
22 of this manual, up to the end. The door remains OPEN..
7
Set the ENGAGE POSITION: This is the point (in case of overlapping doors) where the 2
Set the ENGAGE POSITION: This is the point (in case of overlapping doors) where the 2
leaves are free to open and close without any interference.
leaves are free to open and close without any interference.
8
Set the value at 25 (factory setting) for both the leaves. In case you need increase the
Set the value at 25 (factory setting) for both the leaves. In case you need increase the
value, note that greater values delay the closing of the Master leaf which starts and stops
value, note that greater values delay the closing of the Master leaf which starts and stops
waiting for the Slave.
waiting for the Slave.
Door Calibration
Door Engage Pos.
Door Engage Pos.
|||||||||||||||||...................
025
9
10
Enter the CONFIGURATION menu of the
Enter the CONFIGURATION menu of the
SLAVE
SLAVE
unit and set the following parameters:
unit and set the following parameters:
NUM. DOORS
= TWO DOORS
NUM. DOORS
= TWO DOORS
2 DOORS OVERLAP
= ENABLE
2 DOORS OVERLAP
= ENABLE
(only if there is door leaf overlap)
(only if there is door leaf overlap)
DOOR TYPE
= SLAVE
DOOR TYPE
= SLAVE
11
Enter the CONFIGURATION menu of the
Enter the CONFIGURATION menu of the
MASTER
MASTER
unit and set the following parameters:
unit and set the following parameters:
NUM. DOORS
= TWO DOORS
NUM. DOORS
= TWO DOORS
2 DOORS OVERLAP
= ENABLE
2 DOORS OVERLAP
= ENABLE
(only if there is door leaf overlap)
(only if there is door leaf overlap)
DOOR TYPE
= MASTER
DOOR TYPE
= MASTER
12
Move both the external switches to position “I”: the 2 doors close very slowly. Test the
Move both the external switches to position “I”: the 2 doors close very slowly. Test the
function by pressing either the OK button of the transmitter congifured to the MASTER
function by pressing either the OK button of the transmitter congifured to the MASTER
or down key of the keypad or the exit button connected to terminal 15 and 16 of the
or down key of the keypad or the exit button connected to terminal 15 and 16 of the
MASTER.
MASTER.
The procedure is over.
The procedure is over.
HOW TO OPEN ONE OR BOTH DOORS
HOW TO OPEN ONE OR BOTH DOORS
MASTER
MASTER
SLAVE
SLAVE
15 16
15 16
15 16
15 16
OPEN BOTH THE DOORS
OPEN BOTH THE DOORS
OPEN ONLY THE MASTER
OPEN ONLY THE MASTER
