CC-ISOBUS CCI 50, Operating Instructions Manual

Page: 254 / 359

CCI.Command
– Set-up for operation
11
3.3 Operating modes
3.3.1 Section Control
To work with the Section Control module, proceed as follows:
1. Start CCI.Command (see chapter 4.2).
2. Make the geometry settings (see Chapter 0).
3. Make the settings for Parallel Tracking (see chapter 4.3.4).
4. Make the settings for Section Control (see chapter 4.3.5).
5. Activate Section Control operating mode and change to map view (see chapter
4.1).
6. Mark out the field boundary (see chapter 4.4.1).
7. Mark out a reference track (see chapter 4.4.8).
8. Process the field in operating modes Parallel Tracking and Section Control .
3.3.2 Parallel Tracking
To work with the Parallel Tracking module, proceed as follows:
1. Start CCI.Command (see chapter 4.2).
2. Make the settings for Parallel Tracking (see chapter 4.3.4).
3. Change to map view (see chapter 4.1).
4. Mark out a reference track (see chapter 4.4.8).
5. Process the field in the operating mode Parallel Tracking .