CC-ISOBUS CCI 50, Operating Instructions Manual

Page: 311 / 359

CCI.Command
– Operation
68
4.4.4.1 Move reference track
To move the Reference track to the current position of the tractor, proceed as
follows:
1. In the field drive to the desired track and press on the button "Move reference
track " (F9) on the touchscreen .
→ The
reference track is moved to its current position.
Note
This function is only available if a reference track has been recorded. Only the
reference track is moved. If the entire field is to be corrected, a reference point
must be set (see chapter 4.4.4.3).
4.4.4.2 Manually move reference track
To manually move an existing reference track left or right proceed as follows:
1. Press the "Manually correct reference track" button (F7 or F8) on the
touchscreen .
→ The
reference track is moved in the selected direction.
Note
This function is only available if a reference track has been recorded. Only the
reference track is moved. If the entire field is to be corrected, a reference point
must be set (see chapter 4.4.4.3).
4.4.4.3 Set reference point
In the first working, the reference point should be set close to a field .
Select a point which can subsequently be used for calibration by approaching it
from exactly the same direction and which is in exactly the same position. It is
recommended that a prominent point, e.g. a gulley lid or a permanent marking in
the entry to the field be selected.
The recorded data can no longer be used if you can no longer find the position of
the recorded reference point.
To set a new reference point at the current position, proceed as follows:
1. Press the "Set reference point" button (F11) on the touchscreen .
→ The reference point is set and is shown in the map.
Note
The reference point is valid for the tractor combination with which it was set.