Page 25 of 40
Take a length of
2mm sealing
material, offer it up to the upper seal
groove, and cut it off a little longer
than is necessary
11.0 Procedure for replacing the air box housing
seal
Apply a thin coat of
cyanoacrylate (superglue)
to the bottom of the groove
Place the pre-cut length in the groove, with some of the
excess length overhanging each end of the groove
Trim the seal level with
the end of the groove
each end. Take care
not to damage the
seating diameter for
the cable seal and the
tube seal. Take care
to
make
the
cut
accurately in line with
the end of the groove,
the cable seal and tube
seal need to make an
effective seal against
the ends of the housing
seal.
Repeat the procedure for
the lower seal groove
