ENG
-33
ENG
M2/-
M1/+
Setting the target cadence zone
You can set the target cadence zone on/off and change the upper/lower limit of the
target cadence zone.
* Stop measurement and perform the resetting operation (page 16) before you can
change the target cadence zone. Unless you perform the resetting operation, “
DATA
RESET
” appears on the screen, preventing from changing the target cadence zones.
* For details of the target zone, see “Use of the target zone” (page 34).
1. Press the
MENU
button in the measurement screen to
switch to the menu top screen.
Switch to the
CDC.ZOne
screen using the
M1/+
and
M2/-
buttons, and confirm with the
SSE
button.
Menu top:
MENU
Changing the menu:
M1/+
M2/-
Confirm:
SSE
2. Select on/off of the target cadence zone using the
M1/+
and
M2/-
buttons.
When using the target cadence zone, select “
On
”, confirm
with the
SSE
button, and then proceed to Step 3.
When not using the target zone, select “
OFF
”, and then
proceed to Step 4.
On
C
C
C
C
C
OFF
:
M1/+
M2/-
Confirm:
SSE
3. Enter the lower zone limit using the
M1/+
and
M2/-
buttons,
press the
SSE
button, and then enter the upper limit in the
same way.
Increase/decrease:
M1/+
M2/-
Confirm:
SSE
4. Pressing the
MENU
button returns to the menu top screen
(
CDC.ZOnE
screen), and confirm the change.
Pressing it again returns to the measurement screen.
To the menu top/measurement screen:
MENU
* You can enter any upper/lower limit; however, the upper limit is adjusted automati-
cally to the lower limit + 1 when the entered lower limit exceeds the upper limit. In
case of the upper limit, vice versa, the lower limit is adjusted in the same way.
(or)
(or)
(or)
(Back)
(Back)
Current setting
Upper limit
Lower limit
