ENG
-13
ENG
* This unit enters the search mode for 5 minutes after starting the ID check.
Press the
SSE
button during the search mode, then “
ID-SKIP
” is indicated and it
proceeds to “Selecting speed unit” screen below. Or, unless a sensor signal is
received in 5 minutes, “
ID-ERROR
” is indicated and it proceeds to “Selecting
speed unit” screen below.
When “
ID-SKIP
” or “
ID-ERROR
” is indicated, this unit is not ready for
measurement because the sensor ID has not been registered even though the
set-up is completed. Be sure to check the sensor ID from the menu screen
“Searching the sensor ID” (page 28).
4. Set the sensor ID
Set the speed/cadence sensor ID.
* This unit requres the sensor ID in order for the computer to receive signal from
the sensors.
* To set the sensor ID , be within 5 m from the bicycle with a speed/cadence sensor
mounted properly (page 7).
* When performing ID Synch, make sure there is no other similar sensors in the
surrounding area. (It may pick up other sensor's ID)
1. Verify that the speed/cadence sensor is mounted properly to
the bicycle.
2. Press the
SSE
button to start searching the speed sensor ID.
When the speed (cadence) is displayed as “
ID-OK
” on the
screen by spinning the rear wheel or crank, searching is
completed.
Start searching:
SSE
3. Press the
MENU
button to proceed to “Selecting speed unit”
below.
To “Selecting speed unit”:
MENU
(Back)
Continue
