ENG
-29
ENG
1. Press the
MENU
button on the measurement screen to
switch to the menu top screen.
Switch to the
SEnSOR-ID
screen using the
M1/+
and
M2/-
buttons, and confirm with the
SSE
button.
Menu top:
MENU
Changing the menu:
M1/+
M2/-
Confirm:
SSE
2. Select the sensor ID to be checked.
Select “
SP1
(speed sensor 1)” and “
SP2
(speed sensor 2)”
using the
M1/+
and
M2/-
buttons.
Selecting the sensor:
M1/+
M2/-
3. Check whether the speed/cadence is mounted properly.
4. Press the
SSE
button to start searching the ID.
When the speed (cadence) is displayed as “
ID-OK
” on the
screen by spinning the rear wheel or crank, synchronizing is
completed.
Start searching:
SSE
5. Pressing the
MENU
button returns to the menu top screen
(
SEnSOR-ID
screen), and confirm the change.
Pressing it again returns to the measurement screen.
To the menu top/measurement screen:
MENU
* This unit enters the search mode for 5 minutes after starting the ID synch.
While “
ID-SKIP
” is indicated, press the
SSE
button in the search mode to cancel
the ID synch, and “
ID-SKIP
” is displayed. Unless a sensor signal is received in 5
minutes, “
ID-ERROR
” is displayed.
When “
ID-SKIP
” or “
ID-ERROR
” is displayed, the ID has not been synchronized
properly. In such a case, the sensor ID retains the previous ID setup. Check
whether the speed/cadence is mounted properly, is mounted properly, before
you check the ID again.
*
SP2
is used when a computer is commonly used for second bicycles. By synchro-
nizing the ID of the second bicycle equipped with a second speed/cadence sensor
and the computer with
SP2
, re-synchronizing the ID is not required every time you
move the computer between first and the second bike.
(or)
(or)
(Back)
(Back)
