Case 1021F, Operator'S Manual

Page: 130 / 366

3 - CONTROLS AND INSTRUMENTS
RCPH10WHL079FAH
4
10. Fan reverse switch (if equipped)
To use the fan reverser let the machine idle in neutral. Depress the fan reverser switch and depress
the throttle to high idle for a minimum of 10 seconds or until debris stops blowing out of the coolers.
Return the machine to idle and release the fan reverser switch. This is a three-position switch. Push
the upper part of the switch for momentary reversal as described above. The center position of the
switch is the automatic position, and the lower position disables the automatic fan.
11. Coupler engagement switch (if equipped)
This switch allows engagement of the attachment from the operator's compartment. Slide the locking
plate toward the center of the switch. Push down on the top of the switch to retract pins for the
attachment. The switch lamp will illuminate when the pins have been retracted. The switch will lock
the pin in the extended position when the bottom of the switch has been pressed and the pins are
extended.
12. Return to dig switch
Push on the top of the function switch for the ON position. This will allow the bucket to return to level
with the ground for digging.
13. Return to travel detent switch
The return-to-travel switch is used to automatically return the loader bucket to the travel position after
you have dumped the loader bucket. Push down on the top of the return-to-travel switch to engage
the return to travel detent. Push the bottom of the switch for the float detent position.
3-64