9
5. POWER PACK OPERATION
5
.
8
Direc on LED
Above the timer is a Direction LED indicating the Cell Electrode direction at that particular
time. Solid Green indicates Forward and Flashing indicates Reverse. The reversing times
can be changed from 5 to 7.5 and 10 hours, please contact your local Crystal Aquatic
Systems agent for assistance.
5
.
9
Water Flow LED
A Water Flow sensor comes standard with your
Talline
unit. If flashing Red this indicates
insufficient flow of water in the cell housing or a fault. Contact your local
Crystal Aquatic
Systems
agent for assistance.
5
.10 Salt Test
Salt Test allows you to check if the salt levels are correct, be pressing the + Bu on and
holding it for 5 seconds. All 8 Output LED’s indicate salt levels are correct and if they do
not reach 8 then salt levels need to be checked or contact your local
Crystal Aquatic
Systems
agent for assistance.
5
.
11
Start Up Procedure
• Ensure 10amp wall outlet supply switch is turned "OFF".
• Cell Switch in the "OFF" posi on.
•
Timer Switch in the "MANUAL" posi on.
•
Turn the 10amp wall outlet supply switch "ON".
•
The pump should start up and prime.
Allow the pump to run for 2 minutes and repair any leaks if needed
•
.
•
Turn the Cell Switch to "ON" un l all 8 Green LED’s light up.
•
Set the Timer to run 6 – 10 hours in the summer and 3 – 6 hours in the winter. Refer to sec. 6
Timer Se ng for further details.
•
•
Now turn the Timer Switch to "AUTO" and leave it here to run automa cally.
A
ll Talline
™
Self
Cleaning
models
are
controlled
by
a
Micro-Chip
controller
t
hat
p
erforms
several
func ons,
including
the
change
of
current
direc on
and
water
sensing.