3. POOL PREPARATION
5
B
efore operating your Talline
™
unit please read the following:
Handy Tips
•
Check your salt levels with your local pool professional before installing your unit.
•
5
– 4
5
Salt levels should ideally be 3 00
500ppm and no more than 000ppm.
•
NEVER ADD SALT DIRECTLY TO THE SKIMMER BOX.
This high concentra on of salt will
pass
through your
filtra on, pump
and other pool equipment.
•
Salt levels above 4000ppm may overload the unit and cause excessive heat.
•
For all new pool installa ons please seek advice from your pool builder before adding
salt as some new surfaces request no salt to be added when ini ally completed.
• The colder the water the lower your output but this does not mean you need more salt.
There will always be less chlorine demand in colder water.
• We recommend 3.5kg per 1000 litres (1 cubM) of pool water and a 50 000 litre (50 cubM)
new pool needs approximately 175kg of salt.
• The unit can operate on mineral/magnesium chloride salts and you should allow an extra
20 – 30% on the ppm for these type of salts.
• Salt should always be added to the shallow end of the pool and allowed to dissolve.
Do not let the salt se le on the floor of the pool as this may cause damage to the surface.
Use your pool brush to mix the salt into the water.
• Running the pump will mix the water and help the salt to dissolve.
• Only run the pump in the first 8 – 12 hours (ensure the cell is switched off) to allow the salt
to dissolve.
• If you press the + bu on un l you reach the top LED (no. 8) then let go and wait for the
output to se le then if all 8 LEDs are on then there is enough salt if it does not reach the
top 8th LED then you either need salt or if the cell is old it may need replacing.
Should you require further informa
tion
visit
www.
crystalas
.com